CONSUMABLE PARTS TO WATCH FOR WEAR

1 pair cams for any one standard tooth outline

2 cam follower bearings

1 Rocker Arm Assembly complete including:

    1 lower rocker arm assembly

    1 upper rocker arm assembly

    4 cone screw bushings (not supplied with No.2 sharpeners)

    4 cone screws w/nuts & washers

    1 rocker arm carriage

    4 rocker spring screws (3 supplied on No.2 & 6 sharpeners)

    3 rocker arm springs

    3 suspender straps

2 Part No. 461 links for rocker arm carriage, new long style (for     No.4 sharpener ONLY)

1 wheel adjusting screw nut

1 wheel adjusting screw

1 wheel adjusting screw pocket

1 trunnion shaft with snap ring

2 grinding wheel arbor bearings

1 grinding wheel arbor pulley

1 variable speed pulley for grinding wheel

1 grinding wheel arbor V-belt

1 face plate w/screws (preferably carbide insert)

1 saw carriage (preferably carbide inserted)

The above list is also a good reference for rebuilding a band saw sharpener (or inspecting the "alleged" rebuilding by another party). If the parts listed above are badly worn, it is a fair assumption that the sharpener was not recently rebuilt